
FreedomMicro Cap Air
One application method. Two cap shapes.
These steps apply to both versions of Freedom Micro Cap Air. Choose the cap shape made for your sensor.
Round cap
FreeStyle Libre 3 & Libre 3 Plus
MiniMed Instinct
Oval cap
Dexcom G7 & G7 15 Day
Stelo
The photos below show the round cap. Follow the same liner, alignment, and application steps with the oval cap.
Before you begin
Have your sensor in place and the correct cap and patch ready. Start with clean, dry skin around your already-applied sensor.
Apply it in six simple steps
-

Peel the first liner
Peel away the larger release-liner section. Keep the smaller section attached and use it as your handle. Keep your fingers off the exposed adhesive.
-

Align the cap
Hold the cap by its rim. Place it on the exposed adhesive, aligning the cap edge with the straight edge of the remaining liner, as shown.
-

Attach the cap
Press the cap onto the exposed adhesive to attach it to the patch. Leave the smaller liner in place for handling.
-

Position and secure
Turn the assembly over and position the cap over your already-applied sensor. Hold the remaining liner and gently secure the exposed patch area to the surrounding skin.
-

Peel the remaining liner
Lift and peel away the smaller liner without touching the adhesive. Gently lay that side of the patch onto your skin as the liner comes away.
-

Smooth and finish
Gently smooth the patch edges onto your skin. Check that the edges lie flat. The cap stays beneath the patch.
View the Complete Photo Guide








Share and get 15% off!
Simply share this product on one of the following social networks and you will unlock 15% off!